Use the carpet kicker and stretch the carpet over the tacks and past the tack strip by 1 4 inch.
Tiling up against carpet.
Work on a single carpet tile at a time when applying any adhesive.
The tack strip for the carpet is installed 1 4 to 3 8 inch from the edge of the tile then the edge of the carpet is cut off at the direct tile edge or it can span the slight gap between the tack.
Unpeel one side of the tape and press it against the back corner of your carpet tile.
Cut the carpet with a slotted blade knife so that it is even with the edge of the tile.
Tiling to existing carpet if i need to tile up to carpet that has already been installed at a doorway for instance i install the tile carefully to within about an inch of the carpet.
If you are using a carpet glue apply the glue in a straight line on each edge on the back of the carpet.
Again i m careful not to get any mortar or grout on the carpet.
Apply carpet tape or glue to the back of the tiles if there s no adhesive.
Part of the series.
Cut the z bar to the length of this area using a hacksaw.
If you re looking for an added level of security then a z bar is one of the best tile to carpet transition options out there.
Step 5 tuck the end of the carpet into the gap between the tack strip and the tile by using a stair tool or a putty knife.
The next step should be to cut at the direct edge of the tile.
It is highly recommended that you lay the tiling before you install the carpet if using this method.
5 fit the z bar right up.
Not only that it delivers a flawless transition between carpet and tile but it also hides the edges of the carpet preventing it from being pulled out by accident.
If you have a deep dark carpet in one room it may be best to avoid placing it directly up against a gleaming white marble in the next room.
After the tile is installed put in a tack strip 1 4 to 3 8 inches from the edge of the tile.
And if the carpet in the hallway is dark red you may not want to contrast this with a green carpet in the bedroom.
Carpet installation repairs.